![]() Let’s say that we want to increase this to 57600. The XBee will reply back with 3, which equates to a baud rate of 9600. The most common change is that of baud rate. ![]() This is a temporary state! For the next few seconds any information sent to the serial port will be used to command the XBee, and the XBee will not forward it on to any listeners. +++ and AT put the XBee into command mode. But if you’ve totally forgotten the XBee settings, you can use this simple method to do a hardware XBee factory reset. Usually it is a matter of mismatched baud rate. If it fails repeatedly, you may be at the wrong communication settings. If it doesn’t work, wait 10 seconds and try again. ![]() ![]() You should get back a reply of “OK” from the XBee. Type the string +++ quickly without pressing the Enter key. Once your terminal program is up and running, open the connection to your XBee port. To find the port the XBee is using, follow the directions for your operating system: for Linux udevadm, or on Windows it is Device Manager.įor Linux minicom, I recommend the terminal options of turning on local echo and adding linefeeds. For a factory-fresh XBee, the communication settings will be: (Mac…you are on your own.) Before starting, you need to know the port the XBee is attached to and the communication settings, just as you would with X-CTU. Windows comes with Hyperterminal pre-installed, but for Linux I downloaded the free minicom program. You can fully configure your XBee via the serial port and a terminal program. ![]() Now this is fine if you already have or want an emulator but really…there is no need for such a heavy-weight solution. As result, if you need to configure an XBee on a different operating system, a Google search brings up repeated suggestions to install a Windows emulator, install X-CTU, then manually update some drivers. If you own an XBee, you likely already know that the official configuration tool, X-CTU, only runs on Windows. Consider this post a corrective to all the over-complicated advice I’ve seen out there. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |